Oct 13, 2024 Leave a message

How To Choose Reasonable Servo Parameters To Improve The Accuracy And Speed Of The CNC Private Server System?

In the process of contour machining, each coordinate axis often requires instantaneous starting, stopping, or changing speed according to different machining shapes. The control system should accurately control the position and speed of each coordinate motion simultaneously. Due to the steady-state and dynamic characteristics of the system, the coordinated motion of each coordinate axis and the accuracy of its position are affected, resulting in shape errors in the contour. Choosing appropriate servo parameters based on mechanical characteristics can simultaneously improve the accuracy and speed of the system.
1. Position loop gain
Position loop gain is an important parameter in the servo feed system of CNC machine tools. The larger the gain of the position loop, the faster the response, and the higher the accuracy of position control, but it is also easy to cause oscillation in the position loop. In the servo feed system of CNC machine tools, if the position loop gain of each feed axis does not match, contour errors will occur. So, the position loop gain settings of each feed axis should match each other.
2. Speed loop PI regulator
P refers to proportional control, while I refers to integral control. The speed regulator is a proportional integral (PI) regulator, and its PI value depends entirely on the load size of the driven coordinate axis and the mechanical characteristics such as transmission stiffness and clearance of the mechanical transmission system (guide rail, transmission mechanism). Once these characteristics undergo significant changes, the mechanical transmission system needs to be repaired first, and then the speed loop (PI) regulator needs to be readjusted. The speed loop gain is an important parameter that determines the responsiveness of servo control and has a significant impact on the cutting accuracy and cycle time of machine tools.
3‌. Speed feedback filtering factor
Set the characteristics of the speed feedback low-pass filter. The larger the value, the lower the cutoff frequency, and the less noise the motor generates. If the load inertia is large, the set value can be appropriately reduced. The value is too small, and the higher the cutoff frequency, the faster the speed feedback response. If a higher speed response is required, the set value can be appropriately reduced.
4. Maximum output torque setting
Set the internal torque limit value of the servo drive. The set value is a percentage of the rated torque, and this limit is valid at all times. The positioning completion range is set under the position control mode, and the positioning completion pulse range is determined. This parameter provides the basis for determining whether the driver has completed positioning under position control mode.
By setting and adjusting the above parameters reasonably, the accuracy and speed performance of the CNC servo system can be effectively improved, ensuring the efficient operation and high-quality processing of the machine tool.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry